| drobom − CLI for managing drobo units | 
| drobom [ options ] <command> [ arguments... ] | 
| options is one of: | 
| −c, −−command | 
| the command to execute. | 
| −d, −−device | 
| the device to operate on (default searches all devices and picks first one found.) | 
| −h, −−help | 
| print a usage message | 
| −v, −−verbose | 
| verbosity, a bit-field to trigger increased output as needed, mostly for debugging. 1 - General, 2 - Hardware Dialog, 4 - Initiation, 8 - DMP layer, 16- Detection 64 will print everything... (default: 0, as terse as possible.) 128 enables simulation mode (for testing when no Drobo is available. Dangerous!) | 
| −V, −−version | 
| print the version id. | 
| command is one of: | 
| blink | identify the drobo by making the lights blink | |||
| diag | dump diagnostics file into /tmp directory | 
| diagprint <diagdumpfile> | 
| print diagnostics file to standard output <diagdumpfile> the diagnostic dump file to print. | 
| fwcheck query drobo.com for updates to firmware for the given Drobo | 
| fwload load a specific firmware for the given Drobo. Arguments: <fwimage> the firmware file to load. | 
| fwupgrade | 
| upgrade the firmware to the latest and greatest, recommended by DRI | 
| help | print this text | 
| info <toprint> | 
| print information on a Drobo. The <toprint> argument is a comma separated list of the values below (default is to print all of them): config, capacity, protocol, settings, slots, firmware, status, options, luns | 
| list | show device files for all Drobos found. | 
| name <newname> | 
| Set the name of the Drobo to the given value ( only firmware > 1.3.0 supports this command ) | 
| settime sync Drobo’s clock to UTC | 
| setlunsize Set the size of LUNS on device. Arguments: | 
| <sz> integer number of TiB to set the lunsize to <confirmation> Specify ’PleaseEraseMyData’ if you really mean it Note: After execution, Drobo reboots, wait a few minutes before accessing again | 
| shutdown | 
| shutdown drobo (DRI calls this ’standby’) | 
| status | report how is the Drobo doing | 
| device | 
| raw block device of a drobo (i.e. /dev/sdz) . If not given, assumes all attached drobos. | 
| This manual page was written by Chris AtLee <chris@atlee.ca> for the Debian project (but may be used by others). |